Manuels Connexes pour Nadoli DOL5560C-CL
Sommaire des Matières pour Nadoli DOL5560C-CL
- Page 1 DOL5560C-CL 60" Linear Opening Shower Door Dimension of shower door: (1450-1475) x 1850(H)mm / (57"-58") x 72-13/16"(H) Profile adjustment : +25mm/1" Rev. April 11,2018...
- Page 2 General Information Informations générales Please inspect the product immediately upon receipt for transit damage, missing packs / parts or manufacturing fault. Damage reported later cannot be accepted. Please handle the produck with care avoiding knocks and shock loading to all sides and edges of the glass. *Prière de bien inspecter le produit dès la réception pour s’assurer qu’il n’a aucun défaut, bris ou pièces manquantes.
-
Page 3: Assembly Drawing / Dessin D'assemblage
Assembly Drawing / Dessin d'assemblage Required Parts / Dessin d'assemblage Quantity Quantity Description Description Numéro Description Quantité Numéro Description Quantité Wall posts Magnetic seals Montant du mur Joint magnétique Fixed panels Splash guard Anti-éclaboussure Panneau fixe Drip seals Allen wrench Clé... -
Page 4: Installation Steps: / Étapes D'installation
Installation Steps: / Étapes d'installation: Step 1 / Étape 1 a. Using a level ensure jambs (1) are plumb the mark the outside edge with a pencil. Then mark your screw holes that are on the inside of the jamb. *En utilisant un niveau s'assurer que les montants (1) sont d'aplomb puis marquez le bord extérieur avec un crayon. - Page 5 Step 3 / Étape 3 Connect top and bottom rails (4) to fixed panels (2). Ensure rail cap bases (9) are placed on the glass before using rail fxing screws (16). Cap off with rail caps (10). Do not over tighten as this may damage rail cap bases (9).
- Page 6 Now dill 4 equally spaced 3.2mm holes into the wall jambs (1) on the Step 5 / Étape 5 INSIDE of the screen. Make sure that your drill holes are more than 20mm back from the edge of the glass, when using smallest screen size, otherwise you may break the glass.
- Page 7 Step 7 / Étape 7 Slide hinge caps (8) over both hinges (7). *Faites glisser les bouchons charnière (8) sur les deux charnières (7). Hint: Place a small amount of silicone under each cap before installing to ensure cap remain in position permanently.