Polaris Industries GLACIER Mode D'emploi page 10

1) Fasten the front hook (#5) onto the rear pivot (#2) using a
hex bolt (#15), a
1/2" nc X 1-1/2"
a thin nylock nut (#22).
1/2" nc
2
15
1) Fasten the snow plow (#A) onto the pivot (#6) using
nuts (#26). NOTE : To allow blade to trip, do not overtighten.
2) Insert the springs (#9) in the snow plow upper holes (#A), and fasten the other end of the springs to the pivot (#6) using
(2)
eye bolts (#17) and
M8-1.25 X 60mm
17
24
16
FRONT VIEW
FRAME ASSEMBLY INSTRUCTIONS
flat washer (#29), and
1/2" dia
5
22
29
SNOW PLOW ASSEMBLY INSTRUCTIONS
(2) 1/2" nc X 2"
nylock nuts (#24).
(2) M8-1.25
9
A
6
26
29
2) Attach one end of the lever spring (#10) onto the locking arm
(#4) and fasten the other end to the
bolt (#18). Fasten using the
3) Fasten the hook of the winch onto the pivot (#6).
NOTE : The electric winch (Superwinch model, P/N 2874772)
requires the winch bracket (P/N 2874901).
6
hex bolts (#16),
(4) 1/2" dia
NOTE : If the plow frame (#1) interferes with the ground
during plowing, it can be lifted by changing holes of the rear
bracket.
2
29
16
1
4
M6-1.0 X 25mm
nylock nut (#23).
M6-1.0
4
10
18
23
P/N 2874901
flat washers (#29), and
(2) 1/2" nc
26
29
A-7510026 Rév. A
carriage
6
nylock
(2)
7510026