Use Of Icons; Programming Procedure; Recall Function - FRIEDLAND D942S Libra+ Manuel D'utilisation

D942S 48342PL_Ed3 2/1/07

Use of icons

In addition to the chime sounds, your chime has a
visual indication to show which device has activated it.
An icon will illuminate when the chime is
activated by a bell push or another compatible
device. The chime supports 3 icons:
Main Back
door door
The 'Main door' and 'Back door' icons are usually
used for bell pushes. The other icons are intended for
use with other compatible devices, such as PIR
movement detectors and Telephone ring detector.
Icons numbered 1 to 3 are also included. The Icons
are self-adhesive, supplied in strips of 3. They can
be changed, if required, by opening the sliding
window of the chime and gently peeling off the
strips.
If desired, the strips can be cut into individual
icons and fixed to the chime in a different order.
Use the Programming procedure to change the
icon associated with a push.
6:31 PM Page 5
!
Alert
symbol

Programming procedure

Learn mode
To enable your chime to learn the identity of your
bell push:
¬ Press the button and keep it pressed. Each
Icon will light in turn. When the Icon you want is
lit, release the button.
¬ While the Icon you have selected is lit, operate
your push. The chime will sound. The Icon will flash.
Unlearn procedure
If you want to remove a push from the chime's
memory:
¬ Press the button and keep it pressed.
Each Icon will light in turn. When the Icon
associated with the push to be un-learnt is
lit, release the button.
¬ Press and hold down both
until a 'beep' sound is heard.
Changing the tune
Changing the tune
Operate the push. While the icon is flashing,
press the button. Press the button again
and the tune will change. Repeat until the
tune you want plays.

Recall function

A short push of the
was last in use.
4
& buttons,
button will flash the icon that