Brooklands The Model 1 Manuel De L'utilisateur page 7

The Model 1
Your Triple-Four watch is self-winding when worn and
has a power reserve of 48 hours from fully wound. To
fully wind the watch, unscrew the crown to position II
and wind in a clockwise direction. The crown should be
wound fully until you feel a slight resistance.
The mechanism is specially modified so that you can
set the date with the hour and minute hands showing
any time. The crown is pulled out to position III to set
the date. Turn the crown in a clockwise direction to set
yesterday's date. Now pull the crown out to position IV
and turn it in a clockwise direction until today's date
appears in the date window. Continue turning to set the
hour and minute hands to the correct time. Push the
crown in to position II and then screw the crown home to
Push the button below the crown to set the chronograph
function to zero. The button above the crown is used
to start and stop the chronograph timer. To read the
chronograph, the lower sub-dial indicates the hours, the
top sub-dial indicates the minutes and the red second
hand indicates the seconds. The gradations on the
outside of the watch face allow timing indications to
English
Operation
position I to seal the watch.
one fifth of a second.
Triple-Four
7