Bosch Tassimo TAS110 Serie Manuel D'utilisation page 25

Fault
Water is dripping from
the brewing unit.
There is water under the
cup stand.
No LED is lit.
All LEDs flashing.
LED lights up even
though there is enough
water in the water tank.
LED lights up al-
though softened water
has been used.
LED and
are simultaneously lit
and the brewing process
is not possible.
Quality of beverages has
deteriorated, e.g. crema
or volume.
Drink volume has re-
duced.
Drink dispensing halts.
specifications Technical
Technical specifications
specifications Technical
Voltage
Frequency
Power rating
Printed on 100% recycled paper
Cause and troubleshooting
Press the T DISC piercing unit into the holder until it
▶
clicks audibly into place.
Condensation has formed due to technical reasons or valves
are clogged with limescale.
Descale the appliance.
▶
→ "Descale the appliance", Page 23
Appliance is in idle mode.
Press
▶
There are problems with the power supply.
Pull out the mains plug, wait 5 minutes and plug it back
1.
in.
If the problem persists, contact the TASSIMO careline.
2.
Float is stuck in the water tank.
Descale the appliance.
1.
→ "Descale the appliance", Page 23
Reach into the water tank and move the float up and
2.
down.
Decalcified water still contains small amounts of lime.
Descale the appliance.
▶
→ "Descale the appliance", Page 23
LED Appliance has a fault.
Unplug the mains plug.
1.
Contact the TASSIMO careline.
2.
Beverage outlet is soiled.
Clean the beverage outlet.
▶
Clean the brewing unit with the T DISC.
▶
Build-up of limescale in the appliance.
Descale the appliance.
▶
→ "Descale the appliance", Page 23
Water tank has not been sufficiently filled.
Fill the water tank with fresh, cold water up to the mark
1.
⁠ .
Keep
2.
220–240 V ∼
50 Hz
1400 W
or open or close the brewing system.
pressed until the desired fill volume is reached.
appliance old of Disposing
Disposing of old appliance
appliance old of Valuable raw materials can be reused by Disposing
recycling.
Unplug the appliance from the mains.
1.
Cut through the power cord.
2.
Technical specifications en
25