Installation Instructions - Sauder 420456 Mode D'emploi

Step 13
å
Carefully stand your unit upright in its fi nal location. We recommend using the SAFETY STRAP for added stability.
å
Carefully cut out the perforated hole in the BACK (E). Insert the end of the SAFETY STRAP that is fastened to the TOP
through this hole.
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY STRAP to a wall
stud, go to your local hardware store for proper hardware.
å

INSTALLATION INSTRUCTIONS:

1. Insert the SAFETY DRYWALL ANCHOR through the WASHER and the end of the SAFETY STRAP.
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall just below the top surface of your
unit so the SAFETY STRAP will not be visible.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
å
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR from your wall. The
nylon sheath will remain behind your wall.
www.sauder.com/service
E
420456
Washer
Safety strap
97
Safety
drywall
anchor
Page 17