Sauder 420456 Mode D'emploi page 13

Step 9
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (E) and lay it over your unit.
A perforation in the BACK (E) has been provided for access
å
to the SAFETY STRAP. Punch out the perforation and push
the SAFETY STRAP through the hole.
Make equal margins along all four edges of the BACK (E).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C2).
www.sauder.com/service
These holes must line up
over the UPRIGHT (C2).
420456
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(45 used in this step)
Before fastening the
BACK, punch out the
Safety strap
perforation and push
the SAFETY STRAP
through the hole.
E
1N
NAIL
Page 13