Brandson 303056 Mode D'emploi page 21

12 Basis
13 Knurled screw (small)
14 Closing screw
15 Check screw
16 Knurled nut for closing screw
17 Shim
18 Fixing screw for basis
19 Stand pipe
20 Protective cage safety screw + nut
5. Assembly
Take the table fan out of the package and check the device as well as the scope
of delivery mentioned in the table above. Please contact the vendor if any part is
missing or damaged.
At first, remove the pre-assembled protective cage locking screws (5) from the
motor unit (11). Now place the rear protective cage (6) on the fan unit (8). Make
sure that the handle (7) is facing up. Tighten the protective cage firmly using the
mounting nut (5). Then insert the rotor blade (3) on the motor shaft (8) and fix it
with the appropriate fixing screw (4) sidewise of the rotor blade.
Caution: Make sure that the notch of the motor shaft (8) is in the correct position.
Mount the front protective cage (1) onto the rear protective cage. A hole is provid-
ed for the locking screw at the bottom of the two protective cages.
Insert the locking screw through the hole of the front and rear guards and fasten it.
Then press the protective cage - fixing bracket (2) over both grids.
Now remove the fixing screw (18) and the shim (17) from the stand pipe (19) of
the fan. Then you can place the basis (12) in the centre of the stand pipe (19) and
fix it using the shim (17) and the fixing screw (18). The table fan is ready for use.
English
21