Timer Function - ARENDO 304940 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

8. Initial use
Place the container on the motor unit. Then connect the power plug of the appli-
ance into a properly installed mains socket.
Make sure that the container is placed correctly (seen from front: Handle to the
left). Now open the top of the blender jar and put in the required ingredients.
Do not use dry ingredients and ensure that there is enough liquid
in the blender jar. Add liquid (eg water) if necessary.
Select the desired program or the desired speed by pressing the "Speed" button.
The display shows the current speed level. Start the appliance using the "ON / OFF"
button. The blender will then start to chop the chosen ingredients into smaller
pieces. Adhere to the prescribed operating time. Do not exceed the blending time
under any circumstances.
The blender runs at maximum speed as long as the "PULSE" button is kept pressed.
After completing the blending process, please remove the blending jar from the
base unit and disconnect the plug from the socket.
Note: The appliance is designed only for brief periods of operation. Allow the ap-
pliance to cool down adequately after about 2 - 3 minutes of continuous operation
before you reuse it!

8.1 Timer function

Press the "Timer" button in Standby mode. The 3-bit digital display shows
"000" by default. Then press the "Timer" button repeatedly to set the time. It
is incremented each time you press the button (one increment is equal to 10s).
Pressing the button for a long time allows you to set the time in faster increments
(3 increments / second).
28
English

Publicité

Table des Matières
loading

Table des Matières