5.
Align and install spacer [4] as shown in FIGURE B.
6.
Torque screw [5] to 9-12 lbs -in (1.0 - 1.3 N m), see FIGURE B.
7.
Install screw [5] enough as to engage the threads, see FIGURE C. Do not fasten all the way as the vertical divider [6]
will slide behind the screw head [5].
8.
Align vertical divider [6] (with threaded hole) as shown in FIGURE C. Slide vertical divider [6] under spacer [4] then
slide towards wall to fully seat against wall as shown in FIGURE C.
9.
Torque screw [5] to 9-12 lbs -in (1.0 - 1.3 N m), see FIGURE C.
10.
Install screw [5] enough as to engage the threads, see FIGURE D. Do not fasten all the way as the vertical divider [7]
will slide behind the screw head [5].
11.
Align vertical divider [7] as shown in FIGURE D. Slide vertical divider [7] under spacer [4] until fully seated against
wall as shown in FIGURE D.
12.
Torque screw [5] to 9-12 lbs -in (1.0 - 1.3 N m), see FIGURE D.
4
FIGURE
B
4
4
SEAT DIVIDER
AGAINST THIS WALL
7
FIGURE
D
5
SEAT DIVIDER
AGAINST THIS WALL
THREADED
HOLE
5
6
13.
Torque screw [5] to 9-12 lbs -in (1.0 - 1.3 N m), see FIGURE E.
14.
After dividers [6] and [7] are installed, check the gap between divider [6] & spacer [4] and between divider [7] &
spacer [4]. Ensure the gap does not exceed 1/16" (1.5 mm). Bend flaps downward on spacer [4], if necessary, to
reduce gap. See FIGURE F.
15.
Refer to cover 610GCFFCVR and 610GTFFCVR series installation instructions to complete cover installation.
5
4
6
FLAP
A
FIGURE
C
FLAP
1/16" (1.5 mm)
MAX GAP
7
4
7
6
A
FLAP
4
SECTION A-A
6
ONLY DIVIDERS SHOWN
FIGURE
F
7
5
6
FIGURE
E
FLAP
1/16" (1.5 mm)
MAX GAP