Putting Into Operation; Use - Gorenje KESS4103-GS Mode D'emploi

EN
is placed in order to prevent the de-
vice from being pulled down.
■
Make sure that the connecting cable
is kept out of the reach of small child-
ren and animals. There is a danger of
strangulation!
Notice – Risk of Damage to Material
and Property
■
Switch off the device and pull the
mains plug out of the plug socket if
an error occurs during operation or
before a thunderstorm. When you
pull the mains plug out of the plug
socket, always pull on the mains plug
and never the mains cable!
■
Never pull or carry the base station
by the connecting cable.
■
Protect the device from other heat
sources, naked fl ames, sub-zero tem-
peratures, persistent moisture, wet
conditions and impacts.
■
Never place heavy objects on the
base station or the connecting cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
PUTTING INTO
OPERATION
Please Note!
■
Do not place the device below kit-
chen wall units or similar cupboards.
The rising steam could cause damage
to them!
■
Lay the connecting cable in such a
way that it does not become squas-
hed or bent and does not come into
contact with hot surfaces.
1. Place the base station (6) on the
kitchen unit or another suitable work
12
surface. Ensure there is suffi cient
clear space on all sides (at least 20
cm to the sides and 50 cm above).
2. Connect to a plug socket that is
properly installed. The mains volta-
ge must be the same as that stated
in the technical data for the base
station.
The plug socket must be readily ac-
cessible so that the connection to the
mains can quickly be isolated.
Before Initial Use
Clean the kettle thoroughly before you
fi rst use it to remove any possible pro-
duction residues. To do this, fi ll it with
water up to the MAX marking, allow it
to boil and then pour away the water.
Perform this process at least twice.

USE

Please Note!
■
Make sure that the lid is closed cor-
rectly.
■
Do not operate without water.
1. Press the button for opening the lid
(3).
2. Pour in fresh water (note the
MIN / MAX marking).
3. Close the lid (2).
4. Place the kettle on the base station
(6).
5. Press down the On / Off switch (5).
The operating lamp lights up and the
device starts the heating process.
As soon as the water has boiled, the
device switches off.