Speedaire 437J24A Mode D'emploi page 10

MAINTENANCE AND INSPECTION INSTRUCTION
(CONTINUED)
Disassembly procedure of the reel
1. Unfasten the bolt of the hose stopper (1), slide the hose out into the hose guide (2),
decrease the tension (3,4).
2. Disconnect the inlet hose and unfasten the elbow. (5)
3. Unfasten the bolt (6) which is connecting the frame and drum.
Then take the frame out. (7)
4. Disassemble the drum (9) after taking the snap ring (8) out of the ratchet. At this
moment, it is possible to take the spring out suddenly and it can cause an
accident. Make the gap using the driver or any other tools in advance.
5. Disassemble the shaft (10) and spring (11). If user wants to replace the spring,
spring. Then insert the new spring into the spring case quickly.
6. Assembly is a reversal of the disassembly procedure.
1. Disassemble the hose stopper's bolts.
Slide the hose into the guide roller
and then loosen the spring tension.
3. Detach the circlip, which is attached
beside the drum, then
disassemble the drum.
Figure 5
8
2. Unfasten the bolts which are
fastened on the shaft,
then disassemble the frame.
4. Remove spring and shaft.