Jung 500.600.110 Instructions D'utilisation page 13

eNet actionneur de commutation / à poussoir 8 voies / actionneur volet
roulant 4 voies, modulaire
Operating hours
Extended channel settings "switching"
Parameters
Operating mode
Manual commissioning
Local Operation
Behaviour on voltage return
Timer behaviour, voltage re-
turn
Behaviour after the end of the
disabling function
Manual saving of the scene
values
82581933
J0082581933
0...65535
Basic setting: Current value
Setting options, Basic set­
ting
Switching operation
Push-button operation
Flashing
Continuous on
Continuous off
Basic setting: Switching ope-
ration
On, Off
Basic setting: On
On, Off
Basic setting: On
On
Off
Last value
Configured brightness
Basic setting: Off
Off
Restart
Basic setting: Off
On
Off
no change
Last value
Basic setting: No change
On, Off
Basic setting: On
13/20
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
Explanations
See Device and channels.
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can-
not be reset to the factory set-
ting.
Blocks the output for operation
using the Prog button.
Defines the behaviour of the
output after voltage return.
Specifies whether the timers
for switch-on delay, switch-off
delay and run-on time remain
off after voltage return or whe-
ther they restart. Directly
connected to the parameters
"Switch-on delay", "Switch-off
delay" and "Run-on time".
Behaviour of the output when
a block is removed.
Disables the saving of the cur-
rent actuator state (On/Off) as
scene value in an actuator for
a command via a transmitter.
23.03.2017