Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
|
Regulatory
Safety Testing Approvals
The Fill-Rite TT10 Series Meters have been tested for compliance to
the standards set forth by Underwriters Laboratories (UL), UL Canada,
ATEX, and other testing organizations. To determine which specific
compliances apply to your particular meter, refer to the faceplate
for information and compliance logos.
FLOW METER FOR HAZARDOUS LOCATIONS Exia INTRINSICALLY
SAFE
Class I, Group D, T4; Class I, Zone 0, AEx ia IIA T4 Ex ia IIA T4; IECEx UL
16.0147X; Ex ia IIA T4 Ga;
-40°C < Ta < +60°C
II 1G
Ex ia IIA T4 Ga
DEMKO 16 ATEX 1787X
fillrite.com
TT10 IN-LINE TURBINE METER
INSTALLATION AND OPERATION MANUAL
CE Certification Information
The TT10 Series meters bearing the CE mark have been certified to the
following European Directives:
2011/65/EU: Restriction of the use of certain hazardous
substances in electrical and electronic equipment.
2014/30/EU: Electromagnetic Compatibility
The following standards were used to test and show
compliance:
EN IEC 60079-0: 2018
IEC 60079 Edition 7
EN 60079-11: 2012
IEC 60079-11 Edition 6
UL60079-0 Sixth Edition
UL60079-11 Sixth Edition
CAN/CSA - C22.2 No 157-92
CAN/CSA - C22.2 No 60079-0:2014
CAN/CSA - C22.2 No 60079-11:2015
EMISSIONS
EN 55011:2016+A1:2017 Group 1, Class B, Industrial,
Scientific, and Medical (ISM) Equipment
IMMUNITY
EN 61326-1:2013, Electrical Equipment for Measurement,
Control, and Laboratory Use
IEC 61000-4-2: 2009 ESD
IEC 61000-4-3: 2006 A1:2008 & A2:2010 Radiated Immunity
IEC 61000-4-8: 2010 Magnetic Field
9
Publicité
Table des Matières
