Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
|
TT10 Technical Information
Flow Ports: 1" NPT or BSPP female inlet and outlet
Flow Range: 2 to 35 GPM / 7.6 to 132.5 LPM
Working Pressure (TT10A): 50 PSI (3.4 Bar) MAX UL / 300 PSI
(20.7 Bar) Burst
Working Pressure (TT10P): ≤120°F (49°C): 125 PSI (8.6 Bar),
>120°F (49°C): 50 PSI (3.5 Bar)
Storage Temperature (Liquids not Present): -40 to 140°F
(-40 to 60°C)
Operating Temperature (TT10A) : -40 to 140°F (-40 to 60°C)
Operating Temperature (TT10P) : -15 to 140°F (-26 to 60°C)
Measurement Accuracy: ±1.0% (after field calibration)
Measurement Repeatability: ±0.30% (batch sizes ≥ 2 gallons)
Measurement Units: Ounce, pint, quart, liter, gallon
Wetted Materials (TT10A - Fuel): 304/316 stainless steel,
aluminum, acetal, gold
Wetted Materials (TT10P - Chemical): 304/316 stainless steel,
polypropylene, UHMWPE, gold
Fluid/Viscosity Compatibility
The TT10 Series meters will handle most fuels with viscosities in the range of 0.4 cSt to 79 cSt.
You may meter fluids that exceed a viscosity of 79 cSt, but accuracy will be limited to the calibration flow rate. Set the meter for CAL 19 and follow the
calibration described in this manual.
If in doubt about compatibility of a specific fluid, contact the supplier of the fluid to check for any adverse reactions to the listed materials in the
Technical Information section of this manual.
Approved Fluids:
•
Gasoline*
•
Kerosene*
•
DEF (AUS32)**
•
Herbicides**†
•
Diesel*
•
Hexane*
*Compatible with TT10A fuel models only
**Compatible with TT10P chemical models only
†Contact the chemical supplier for wetted materials and viscosity compatibility
Installation
NOTICE
Excess sealant tape or thread compound upstream of the meter can break free and jam or impair the rotor and cause meter failure. Use of an
appropriate amount of thread compound is the preferred method of installation.
Use a compatible sealant tape or thread compound on all threaded joints.
1.
Determine correct direction for fluid flow and point the arrow on the underside of the meter body in that direction. Installing the meter in the wrong
direction of flow will significantly impact the performance of the meter.
2.
Thread the hose or pipe into ports until snug. Be careful not to cross thread when starting threads or over-tighten the meter.
fillrite.com
TT10 IN-LINE TURBINE METER
•
Heptane*
•
Mineral Spirits
Totalizer Range: 0 - 90,000,000 units
Batch Range: 0.00 - 9999 units (blinks when batch exceeds 9999)
Display: -40 to 140°F (-40 to 60°C)
Power: 2 approved alkaline batteries (see Battery Replacement section)
Memory: Preserves meter/calibration totals when replacing batteries
Safety: Intrinsically safe for use in hazardous locations
•
Non-Potable
Fresh Water
•
Pesticides**†
INSTALLATION AND OPERATION MANUAL
4
Publicité
Table des Matières
