Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
inner container may produce different results (inc. failure) therefore we suggest you
use always the original inner container.
> installation/setup
The
can be installed in a ventral container or in the usual container of our
WINDSOs cube
harness.
In both cases we must make sure of the correct connection. The cube has only 1 riser.
The
is not equipped with a delayed opening system nor is it designed for
WINDSOs cube
free fall, so the process will always be: first open the parachute by pulling the handle and
then release off the paraglider in case you need it and never the other way around.
The installation must always be carried out by specialists with extensive experience or in
a parachute inspection, folding and repair center, of course following the instructions in
this manual.
The inner container of the
is equipped with three possible anchoring points
WINDSOs cube
for the drive handle. One on top, one on the side and one on central part.
It is very important to choose the right one, depending on the location of our
WINDSOs
. In case of using a ventral container, the most common will be the central anchor
cube
point of the container. We will always check the correct functioning of the parachute
Publicité
Table des Matières
