Storage - WINDTECH WINDSOS CUBE 100 Manuel

12
Install the zig-zg folded package in the container and fold the flaps closed. You can use
an object (pencil, etc.) to block the rubber bandwhile closing the flaps of the container.
Once installed, you must now secure the lines with elastic bands (do not use old or dete-
riorated rubber bands and put new rubber bands each time you fold the parachute). Make
three folds the width of the container and use a support if necessary to make the skeins.
They should be about 20 cm wide and forming 8 shape alternating the direction of rota-
tion. Once the lines are stored there should be 90 cm to the main sling which allows the
parachute to be removed without undoing the line packing.
Remove the pencil or whatever was used to block the elastic band and now block it with
the lines. There should be about three fingers of lines sticking out of the rubber to block
teh package
Now you have the Cube ready to be installed on the harness or in an front container.
> storage
.
Store in a dry place, away from chemicals, ultraviolet light and high tem-
WINDSOs cube
peratures. If your equipment is damp, open it up and let it dry. Always keep the fabric
and lines of your chute clean, as dirt or different chemical agents can damage them. If
necessary, clean it only with water and a soft sponge. This must be done if our equip-
ment was in contact with salt water. Avoid contact with oils, solvents and the like, they
would significantly damage their materials. Life span of this parachute is 10 years.
In case you need a spare parts (rubbers, main bridle, lines) please contact Windtech
to make the order of them.