Stihl KB-MM Notice D'emploi page 7

Check the work site –
rocks, metal objects etc.
may be caught up and
ejected – risk of injury!
Operate your power tool at normal
walking pace only.
Be extremely cautious when pulling the
power tool towards you because of the
risk of injury from contact with the
rotating attachment.
Make sure you always have a firm and
secure footing.
Be extremely cautious when changing
direction with the power tool – especially
on slopes.
On slopes, always work parallel to the
gradient to reduce the risk of injury from
slipping or contact with the attachment.
Never work on steep slopes because of
the risk of injury through loss of control
of the power tool.
Special care must be taken when
working in overgrown terrain.
When clearing leaves, take care not to
harm small animals.
Be particularly alert and cautious when
wearing ear protection because your
ability to hear warnings (shouts, alarms,
etc.) is impaired.
Take breaks when you start getting tired
or feeling fatigue – risk of accidents!
Work calmly and carefully – in daylight
conditions and only when visibility is
good. Proceed with caution, do not put
others in danger.
KB-MM, KW-MM
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting". Make sure the safety
devices are working properly. Never use
a power tool that is no longer safe to
operate. In case of doubt, contact a
dealer.
Do not touch the attach-
ment while the engine is
running. If the attachment
becomes jammed by an
obstruction, switch off the
engine immediately
before attempting to
remove the obstruction –
otherwise, risk of injury!
Opening the throttle while the
attachment is blocked increases the
load and reduces engine speed. The
clutch then slips continuously and this
causes overheating and damage to
important components (e.g. clutch,
polymer housing components) – and this
can increase the risk of injury from the
attachment moving while the engine is
idling.
Check the sweeping attachments at
regular short intervals during operation
or immediately if there is a sudden
change in behavior:
Shut off the engine, hold the
–
machine securely.
Check condition and proper
–
mounting.
Replace damaged sweeping
–
attachments immediately.
Clean the attachment and deflector at
regular intervals during operation.
Shut off the engine
–
Use gloves
–
Remove debris from between the
–
sweeping attachments and from the
area around the gearbox and
deflector.
To reduce the risk of injury, shut off the
engine before changing attachments.
After Finishing Work
After finishing work or before leaving the
power tool unattended: Shut off the
engine.
Maintenance and Repairs
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the MultiTool and
MultiEngine instruction manuals. Have
all other work performed by a servicing
dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the power tool. If you
have any questions in this respect,
consult a servicing dealer.
English
5