Corsair T1 RACE Mode D'emploi page 9

5. Chair back to seat assembly.
A. Remove the screws from the seat back
using the M8 Allen key provided.
B. TIP: Start with the right side of the
chair with the recline mechanism. It is
much easier to start on this side as the
mount point is fixed in place. Do not
tighten the screws down completely
until you have both sides (all four
bolts) started in the seat back.
C. Use the screws taken from the seat
back to attach the seat cushion and
the seat back together.
5 5 5
6. Place seat assembly onto
the chair base assembly by
inserting the gas lift cylinder
into the center hole in the seat
control base.
A. Make sure the seat assembly is
firmly pressed down into place
before using the chair.