Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Next, remove the inner filter screen by twisting it in a
counterclockwise motion, unscrewing it from the intake
(Ex. 18).
Ex. 17
• Thread the included AquaSurge Low Suction Intake
Attachment with the included flat rubber washer hand-
tight onto the intake of the pump with the filter screen
sitting parallel to the ground (Ex. 19). This attachment will
maximize the amount of usable water in the basin.
• Loosen the collar in the center of the rotational ball and
rotate until the inlet and outlet form a 90º angle (Ex. 20).
• Attach the rotational ball to the outlet of the pump with the
included flat rubber washer (Ex. 20).
Ex. 19
• Next, locate the AquaBasin Plumbing Adapter and thread
it into the bulkhead from the inside of the basin, hand-
tighten until secure (Ex. 21).
• Place the pump into the basin and attach the threaded
collar of the AquaBasin plumbing adapter to the rotational
ball output with the flat rubber washer (Ex. 22).
Ex. 21
NOTE: Replace the pump access panel at this time to
prevent dirt and debris from making its way into the basin
during the remainder of the installation.
STEP 9
BACKFILLING
• Once the pump and plumbing installation is complete,
check again to make sure the AquaBasin is level.
☎
aquascapeinc.com |
CAN (866) 766-3426 |
• Thoroughly backfill the sides with sand or dirt to prevent
any future shifting of the basin.
• After backfilling, check once again to ensure the basin
remains level from front-to-back and side-to-side.
STEP 10
UNDERLAYMENT AND LINER INSTALLATION
• Once backfilled and level, it is time to add the
underlayment and liner. Refer to (Ex. 23) throughout the
process to ensure proper component placement.
Ex. 18
Geotextile Underlayment
Liner
• Remove any sharp objects from the location where the
liner will be placed to prevent damage during installation.
• Clear an approximately 3"
(8 cm) deep gap between
the outside edge of the
basin and the soil along the
two sides opposite of the
pump access. Tuck one
of the strips of geotextile
Ex. 20
underlayment lengthwise
into the trough (Ex. 24).
• This geotextile
underlayment will lay
against the surrounding soil
to prevent soil built up for
the waterfall from eroding
into the basin (Ex. 23 and
25).
• Next, position the pre-cut
EPDM liner on the basin,
reaching from one corner
to the other (Ex. 23 and
26). The liner will retain the
water in the waterfall as it
travels from the spillway
Ex. 22
back into the basin. Be
sure to provide enough
slack for the liner to drape
into the trough around the
perimeter of the basin
(Ex. 23).
☎
US (866) 877-6637
Ex. 23
Ex. 24
Ex. 25
Ex. 26
7
Publicité
Table des Matières
