Qstarz BT-Q1000XT Guide D'installation Rapide page 10

English
...................................................................................................................................................
.............................................................
Start Log
(Time schedule)
Stop Log
(Time schedule)
POI button
Memory
exhausted
Sleep mode
Speed Alarm
*Beeper can be turned off from software -> config GPS.
J-3 GPS Features
1. Baud Rate: 115,200 bps / Datum: WGS-84;
Hot/Warm/Cold Start: 1/33/35 sec. (averaged)
2. 66-channel Bluetooth GPS Receiver with super high
sensitivity at -165dBm
3. Bluetooth Version: V1.2 / SPP profile / Class 2 with 10
................................................................................................................................................................................
.........
10
www.Qstarz.com
2 long
beeps
1 long
beep
3 short
beeps
3 long
beeps
1 long and
1 short
beeps
1 short and
1 long
beeps
At Nav mode, 2 long
beep to enable the Log
when present time is
within the preset time
schedule.
At Nav mode, 1 long
beep when it reaches
the ending time of
preset time schedule.
3 short beeps when POI
button being pressed
3 long beeps when the
device is out of
memory
1 long and then 1 short
beep when the device
enters sleep mode
1 short and 1 long
beep when the device
reach over the speed
and time interval set in
Software>Config GPS.