Drive Medical RTLREB18DDA-SF Instructions De Montage page 3

5. Slide the pin of the "E" Clip into the
receiving port on the outside of the
frame Take the thumb screw and
place into the receiving port on the
inside of the frame and turn
clockwise until tight. Repeat for the
other caster. (figure C)
6. Locate the port for the rear axle on the bottom back of the frame (figure D).
Depress the spring loaded button on the center of the rear wheel and slide the
axle into the frame of the wheelchair. There is a spring loaded pin in the axle that
will "click" when the axle is securely positioned. Repeat for the other wheel.
assembly instructions
Figure D
Figure C
Rear Axle
Port
To remove wheel, depress spring
loaded button and slide wheel
out from axle port.
E-Clip
Thumb
Screw