Hella marine 2XT 959 630-10 Serie Instructions De Montage

Part Number: 2XT 959 630-xxx
Hella-New Zealand Ltd.
LED COURTESY LAMP, SURFACE MOUNT
Lamp Mounting Instructions
4mm Ø bolts with a maximum head height of 4.5mm (not included) are recommended to mount the lamp.
Ensure the lamp is mounted on a flat surface. The housing may be used as a template for the mounting holes. Drill
two mounting holes up to 4.5mm Ø 28.5mm apart, and mount the housing. Drill cable entry hole in the centre of the
mounting holes at a recommended size of 4.5mm to 8mm Ø, and ensure the hole has no sharp edges to chafe the
cable. Push the cable through the hole and connect the wiring (see wiring instructions). Push the LED module firmly
into the housing until it snaps into position.
LED Module Instructions
To remove the LED module before installation hold the housing near the base and push firmly on the back of the module.
Note: The LED module is fully sealed and has no serviceable components.
The LED module is securely fastened to prevent dislodging in service, and removal would not normally be required. If it
becomes necessary to remove the module after installation, insert a small blade on both sides of the LED module and
the housing at the correct position and prise the module free from the housing. (See diagram below)
Wiring Colour Coding
Lamp is polarity conscious. The reversal of the polarity will not damage this product but will inhibit its function.
Hella recommends wire connections be soldered, and heat shrink tubing applied to seal the joint.
Note: Lamp must be protected by a fuse rated at 2 amperes maximum.
Part Number Lamp Colour Cable
Earth (-)
2XT 959 630-10x Amber Lamp Black
2XT 959 630-15x Amber Lamp Black
2XT 959 630-25x Blue Lamp Black
2XT 959 630-30x Red Lamp Black
2XT 959 630-35x Red Lamp Black
2XT 959 630-45x White Lamp Black
2XT 959 630-55x Green Lamp Black
For general comments about Hella's product please contact us on E-mail at techfeedback@hella.co.nz
Cable Voltage Power Consumption
Positive (+)
Amber 12V 0.5 watt
Amber 8-28V 0.5 watt
White/Red Trace 10-33V 0.5 watt
Red 12V 0.5 watt
Red 8-28V 0.5 watt
White/Red Trace 10-33V 0.5 watt
White/Red Trace 10-33V 0.5 watt
Part Number: 2XT 959 630-xxx
Hella-New Zealand Ltd.
LED COURTESY LAMP, SURFACE MOUNT
Lamp Mounting Instructions
4mm Ø bolts with a maximum head height of 4.5mm (not included) are recommended to mount the lamp.
Ensure the lamp is mounted on a flat surface. The housing may be used as a template for the mounting holes. Drill
two mounting holes up to 4.5mm Ø 28.5mm apart, and mount the housing. Drill cable entry hole in the centre of the
mounting holes at a recommended size of 4.5mm to 8mm Ø, and ensure the hole has no sharp edges to chafe the
cable. Push the cable through the hole and connect the wiring (see wiring instructions). Push the LED module firmly
into the housing until it snaps into position.
LED Module Instructions
To remove the LED module before installation hold the housing near the base and push firmly on the back of the module.
Note: The LED module is fully sealed and has no serviceable components.
The LED module is securely fastened to prevent dislodging in service, and removal would not normally be required. If it
becomes necessary to remove the module after installation, insert a small blade on both sides of the LED module and
the housing at the correct position and prise the module free from the housing. (See diagram below)
Wiring Colour Coding
Lamp is polarity conscious. The reversal of the polarity will not damage this product but will inhibit its function.
Hella recommends wire connections be soldered, and heat shrink tubing applied to seal the joint.
Note: Lamp must be protected by a fuse rated at 2 amperes maximum.
Part Number Lamp Colour
2XT 959 630-10x Amber Lamp
2XT 959 630-15x Amber Lamp
2XT 959 630-25x Blue Lamp
2XT 959 630-30x Red Lamp
2XT 959 630-35x Red Lamp
2XT 959 630-45x White Lamp
2XT 959 630-55x Green Lamp
For general comments about Hella's product please contact us on E-mail at techfeedback@hella.co.nz
Cable Cable Voltage Power Consumption
Earth (-) Positive (+)
Black Amber 12V
Black Amber 8-28V
Black White/Red Trace 10-33V
Black Red 12V
Black Red 8-28V
Black White/Red Trace 10-33V
Black White/Red Trace 10-33V
0.5 watt
0.5 watt
0.5 watt
0.5 watt
0.5 watt
0.5 watt
0.5 watt