Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Voltage
Amperes
Cable rating (Amperes)
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
10
7.1 - 12.0
15
220/240
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
10
7.1 - 12.0
15
12.1 - 20.0
20
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Selecting the operating mode (fig. B)
The percussion drills can be used in two operating
modes:
Rotary drilling:
for steel, wood and plastics.
Percussion drilling:
simultaneous rotating and impacting for
concrete and masonry drilling operations.
• Select the required operating mode by rotating
the symbol on the mode selector (5) towards the
respective symbol on the gear housing.
Inserting and removing a bit (fig. A)
Keyed chuck
• Open the chuck by turning the sleeve (9)
counterclockwise and insert the bit shank.
• Put the chuck key (10) into each hole in the side
of the chuck and turn clockwise until tight.
Keyless chuck
• Open the chuck by turning the sleeve
counterclockwise and insert the bit shank.
• Tighten firmly by turning the sleeve clockwise.
• To remove the bit, proceed in reverse order.
19
All manuals and user guides at all-guides.com
6
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
15
20
20
15
20
25
25
6
6
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
15
15
15
15
20
20
20
20
25
Fitting the side handle (fig. A)
The side handle (6) can be fitted to suit both
10
RH- and LH-users.
15
20
Always use the Drill with the side handle
25
properly assembled.
-
• Loosen the side handle.
6
6
• For RH-users, slide the side handle clamp over the
43 mm collar behind the chuck, handle at the left.
15
15
• For LH-users, slide the side handle clamp over the
43 mm collar behind the chuck, handle at the right.
20
-
• Rotate the side handle to the desired position
and tighten the handle.
Setting the drilling depth (fig. C)
• Insert the required drill bit into the chuck.
• Slacken the side handle (6).
• Fit the depth adjustment rod (7) through the hole
in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse slider (fig. D)
• To select forward or reverse rotation, use the
forward/reverse-switch (3) (see arrow on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Two gear selector (fig. E)
Your tool is fitted with a two gear selector to vary the
speed/torque ratio.
• Release the variable speed switch and select the
required position. This can be done either with
the tool switched OFF or running under no load
condition. Always align the selector with the
arrow on the gear housing:
1 low speed/high torque
(drilling large holes, driving large screws)
2 high speed/low torque
(drilling smaller holes, drilling in wood)
For speed rates, refer to the technical data.
• Do not change gears at full speed or during use.
E N G L I S H
en - 5
Publicité
Table des Matières
