Storage And Maintenance; Operation; Storage - INFOSEC UPS SYSTEM E4LCD1000 Mode D'emploi

Fault code is shown as 1, 2, 3, 4,
11, 12, 13 and 41 on LCD display
and alarm sounds continuously.
Battery backup time is shorter
than nominal value
The icon and the warning
code flashing on LCD
display and alarm sounds every
second.

5. Storage and Maintenance

5-1. Operation

The E4 LCD UPS system contains no user-serviceable parts. If the battery service life
(3~5 years at 25°C ambient temperature) has been exceeded, the batteries must be
replaced. In this case, please contact your dealer.
Be sure to deliver the spent battery to a recycling facility or ship it to your dealer
in the replacement battery packing material.

5-2. Storage

Before storing, charge the UPS for 5 hours. Store the UPS covered and upright in a cool,
dry location. During storage, recharge the battery in accordance with the following table:
Storage Temperature
-25°C - 40°C
40°C - 45°C
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 11 10 AA 59 203 04
All manuals and user guides at all-guides.com
A UPS internal fault has
occurred. There are two
possible results:
1. The load is still
supplied, but directly from
AC power via bypass.
2. The load is no longer
supplied with power.
Batteries are not fully
charged
Batteries are defective
Fan is locked or not
working
Recharge Schedule
Every 3 months
Every 2 months
Contact your dealer
Charge the batteries for at
least 5 hours and then
check capacity. If the
problem persists, contact
your dealer.
Contact your dealer to
replace the battery.
Check fans and notify
dealer!!
Charging Time
1-2 hours
1-2 hours
40