Halo L805 Serie Instructions D'installation page 2

HALO
To Install Unit on Track (Figs 2G & 2H):
Step 1.
Insert CONTACT HEAD into track.
Step 2.
Locate POLARITY GROOVE on adapter and TRACK POLARITY LINE.
Twist mounting adapter approximately 1/4 turn (90°) until it locks into track
opening and POLARITY GROOVE on adapter aligns with TRACK
POLARITY LINE (Figs. 2G & 2H).
Note:
Forcing the mounting adapter in the wrong direction may damage the
contact assembly. If mounting adapter will not turn easily, twist adapter in
the opposite direction. POLARITY GROOVE on adapter must align with
TRACK POLARITY LINE for proper installation. When correctly installed,
RELEASE BUTTON will be beneath track opening (Fig. 2H).
To Remove Unit from Track:
Note:
Allow unit to cool before removing from track.
Step 1.
Depress RELEASE BUTTON and twist mounting adapter 1/4 turn (90°)
until CONTACT HEAD is free (Fig. 2G).
Step 2.
Remove fixture from track.
Installation Instructions for Halo Architectural Track ('LA' Series)
To Install Unit on Track (Fig 3):
Step 1.
Open SWITCH COVER so contacts are concealed inside adapter. Insure
SWITCH is in the 'off' position.
Step 2.
Insert fixture into TRACK so contacts engage the desired circuit.
Note:
To access the other track circuit, rotate fixture adapter 180°.
Step 3.
Close SWITCH COVER and depress SWITCH to the 'on' position.
To Remove Unit from Track:
Note:
Allow unit to cool before removing from TRACK.
Step 1.
Depress SWITCH to the 'off' position.
Step 2.
Rotate SWITCH COVER 90° and remove from TRACK.
Instructions for Lockable Aiming (Fig. 4)
Step 1.
Aim fixture to desired position.
Step 2.
To lock the fixture's rotation horizontally, insert 0.05 allen wrench, provided, into hole at
housing base (Fig. 4). Turn clockwise to tighten.
Step 3.
To lock the fixture's rotation vertically, insert 0.05 allen wrench, provided, into hole at
fixture neck (Fig. 4). Turn clockwise to tighten.
Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801
FIG. 2G
CONTACT
HEAD
POLARITY
GROOVE
INSERT CONTACT
HEAD AND TURN 90°
SO POLARITY GROOVE
AND TRACK POLARITY
LINE ARE ALIGNED
FIG. 2H
POLARITY
GROOVE
FIG. 3
FIG. 4
VERTICAL
LOCK
´L´ Connectors
page 2
TRACK POLARITY
LINE
RELEASE
BUTTON
TRACK
POLARITY LINE
RELEASE
BUTTON
TRACK
SWITCH
SWITCH
COVER
HORIZONTAL
LOCK
CLP-0001288-rev2 704732INS