Moneual MV-300 Mode D'emploi page 8

All manuals and user guides at all-guides.com
1. Find the lock icons on the side of the reservoir. The arrow is pointing at the locked one.
2. Turn the upper part anti-clockwise and the arrow will be pointing at the unlocked one; then lift.
c. Air outlet filter
1. Take out the air outlet filter for cleaning and change.
Please note:
The sponge filter material in the cleaner will became dusty over time. This is normal and will not affect the
performance of the filter. If the sponge filter is so dusty that suction does not return to 100%, we suggest that
the filter be removed then rinsed under the faucet and allowed to dry for 24 hours by airing not near the fire
or some high temperature objects before refitting into the vacuum. This should be done once six months or
when suction appears to be reduced obviously.
NOTE:
The motor protection filter is under the dust tank; it should be removed and rinsed twice a year or whenever
it is visibly clogged. If the filter is damaged, a new filter should be replaced.
Important:
Please note that there is a safety switch inside the vacuum to prevent the unit from being run with high
vacuum rate. If the vacuum is too high, the safety switch will be turned on. In this case, it can minish the
vacuum rate and protect the motor from being broken.
Note:
The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and
could become damaged.
Important:
All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must
be replaced immediately if they become damaged. Always disconnect the vacuum from the electrical outlet
when checking the filters.
- 7 -