Berner Easy DOT Manuel D'instructions page 15

Changing the batteries
Remove the tester cap (2). Use the enclosed chip (4) or a
suitable tool to lift the battery compartment cover (3) slightly
and at the same time slide it down and off. Remove the spent
batteries and insert new ones. Close the compartment again.
When inserting the batteries, ensure that the polarity is cor-
rect!
Do not dispose of batteries in normal household
rubbish! Use an authorized local collection point!
Technical specifications
Display
Dimensions
Batteries
Protection degree
Measuring range
Optical / 5 LEDs
L = 151 mm / Ø = 23.5 mm
Two 1.5 V AAA Micro
IP 40
DOT 3, DOT 4, DOT5.1
14