Télécharger Imprimer la page

Berner Easy DOT Manuel D'instructions page 13

Masquer les pouces Voir aussi pour Easy DOT:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
WARNING
The responsible body or operator should refer to the instruction manual before use. If the
equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired. The device and its accessories are not allowed to be
changed or replaced, other than authorized by the manufacturer or his agent.
Warning: Not to use the equipment of measurements on mains circuit. Test on a
known source of brake fluid before and after use of the equipment to make sure that
the equipment is functioning correctly.
WARNING
The instructions of the car manufacturer to change the brake fluid must be strictly followed.
This applies regardless of the measurement result obtained by this instrument.
The measurement is considered as additional information and does not replace the
manufacturer's instructions.
To avoid contamination of the fluid due to humidity, the container should be opened
only briefly and also frequent measurement has to be avoided.
Determining the quality of the fluid
Remove the cover on the brake fluid reservoir. Pull off the
cap on the Easy DOT and press the button to turn it on. Se-
lect the proper type of brake fluid by pressing the button sev-
eral times. Press until the white LED is illuminated next to the
required DOT type:
Upper white LED: DOT 4
Lower white LED: DOT 3
Upper and lower LED: DOT 5.1
Submerge the test probe completely but max 1,5 cm in the
brake fluid. You can immediately read the result on the LED
display.
12

Publicité

loading

Ce manuel est également adapté pour:

215220