Publicité
Les langues disponibles
Les langues disponibles
A Open HARDWARE FOR STEP 4.
4
B Attach the REAR TOP CAP COVER (11) to the
UPPER ASSEMBLY (8) using 2 SCREWS (K).
C
Attach the FRONT TOP CAP COVER (12) to the
UPPER ASSEMBLY (8) using 2 SCREWS (K).
Hardware For Step 4
Description
K
Screw
12
8
8
Qty
4
11
K
A Open HARDWARE FOR STEP 5.
5
B Slide the UPPER DUAL ACTION ARM (13) onto the UPPER ASSEMBLY
(8) and attach using 1 FLAT WASHER (L) , 1 HANDLEBAR CAP
(14) and 1 BOLT (M). Torque settings: 64.5 Nm / 47.6 lb-ft.
C
Attach inside LINK ARM COVER (15) to LINK ARM (16) using 1 SCREW (N).
D Slide LINK ARM (16) onto the lower DUAL ACTION ARM (17) and
attach using 1 BOLT (O) and tighten to 80 Nm / 59 lb-ft.
E
Attach outside LINK ARM COVER (15) to LINK ARM
(17) using 2 SCREWS (P) and 1 SCREW (N).
F
Repeat steps B–E on other side.
G Move frame off Styrofoam base and cardboard.
M
L
13
14
P
15
17
N
O
N
A50 SHOWN
Hardware For Step 5
Description
L
Flat Washer
M
Bolt (20 mm)
N
Screw (8 mm)
O
Bolt (25 mm)
P
Screw (12 mm)
8
16
Qty
2
2
4
2
4
Publicité
