cecotec ExtremeTitanium 19000 Manuel D'instructions page 8

ENGLISH
4. OPERATION
1. Plug in the appliance to the mains supply. Make sure the switch is off before plugging in the appliance.
2. Wash the fruit or vegetables you can to juice and cut them into pieces that fit into the feeding
tube. Remove any pit, hard seed, thick skin or hard shell from the foodstuffs before putting
them into the feeding tube.
3. Turn on the switch. You can select between two different positions according to the type of fruit
or vegetable you want to juice. It is recommended not to exceed 1 minute of continuous operation.
4. Insert the fruit or vegetables into the feeding tube.
5. Push the fruit and vegetable pieces carefully until they reach the sieve. Do not press too hard,
as it could damage the product.
6. When you finish juicing the fruits and vegetables, and juice stops flowing from the nozzle,
turn off the power and unplug the appliance. When the motor and sieve stop rotating, turn the
nozzle counterclockwise until the symbol is aligned with the
before taking the jar away from the nozzle.
7. Take the jar away from the juice nozzle after the motor and sieve have stopped completely.
Switch positions
0: Off
1: Low gear for soft fruits and vegetables, such as watermelon, tomato, cucumber, and
strawberries.
2: High gear for hard fruits and vegetables, such as carrot, pear, celery, etc.
14 EXTREMETITANIUM 19000
• Put the jar divider into the jar. Make sure the
grooves on the sides of the jar divider match
the guide on the interior surface of the jar.
Then, close the jar with its cover.
• Insert the juice nozzle into the opening of
the jar. Make sure the juice nozzle is in
position.
• Align the groove in the press with the guide
on the interior surface of the feeding tube
and insert the press into the feeding tube.
symbol on the central ring
5. TROUBLESHOOTING
Problem Possible cause
1. The central ring is not properly
The product does
placed.
not work when
2. The top cover is not properly
turning on the
installed.
switch.
3. The top cover is broken.
The product emits
an unpleasant
smell when This is normal.
switched on for
the first time.
1. Low voltage level.
2. Excessive amount of food.
The appliance 3. Too much pressure exerted
stops while in use. with the press.
4. Temperature control
protection of the motor.
1. Broken sieve.
Too much pulp in
2. Too much pulp in the central
the juice
ring.
1. Improper installation of the
sieve or the appliance is not
placed in an even surface.
Abnormal
2. The appliance is not placed in
vibration or too
an even surface or a footpad is
much noise
missing.
3. High voltage level.
4. Excessive amount of food.
1. Too much pulp in the central
Little juice ring.
production 2. Too much pressure exerted
with the press.
The sieve is stuck Food has blocked the sieve.
ENGLISH
Solution
1. Install the ring properly.
2. Install the top cover properly.
3. Replace the top cover
If the juicer still emits an unpleasant
smell after several uses, contact the
Technical Support Service of Cecotec.
1. Check whether the voltage is too
low.
2. Turn off the power to remove some
food from the feeding tube.
3. Do not press as hard.
4. Resume operation after 20-30
minutes.
1. Replace the sieve.
2. Clean the central ring.
1. Install the sieve in place.
2. Put the product in an even surface
or install the footpad in place.
3. Check whether the voltage is too
high.
4. Turn off the power to remove some
food from the feeding tube.
1. Clean the central ring.
2. Do not press as hard.
Turn off the power to remove some
food from the feeding tube.
EXTREMETITANIUM 19000 15