Nakayama ET6100 Mode D'emploi page 5

EN
Instructions for use
Unauthorized modification can make dangerous machine and lead to severe injury during use. The manufacturer disclaims any liability in case of misuse or
failure to comply with the instructions and / or regulations in force.
Prepare the grass trimmer
CAUTION: Do not plug the machine to the power supply until you fully assembled and set the machine.
Assembly the grass trimmer
- Unpack the unit carefully and make sure the cleanliness, the presence and condition of all parts. If in doubt, contact your dealer.
- Install the handle using the four screws provided.
- Adjust the front handle as shown in Fig 1 and Fig 2.
- Adjust the height of the telescopic tube as shown in fig 3.
Fig. 1
Using the grass trimmer
Before using, always check the presence and correct operation of safety devices. Also 0check the status of the cutting system and its attachment. If
necessary, replace or repair defective components. Use only Nakayama original parts.
WARNING: Never work with a power cord damaged or excessively worn because you might hurt yourself.
Fig. 4
Stop the grass trimmer
- Release the trigger switch to stop the machine
- The machine stops completely after a few seconds.
- Unplug the power socket for safety
Fig. 5
5
Starting the grass trimmer
- Fully unroll the power cord.
- Use cable hook on the upper handle to hang the cord to the machine Fig 4.
- When cutting, make sure the extension cord is always behind you, on the side cut already.
- Hold the grass trimmer with both hands, the protection guard parallel to the floor and the unit close to the body
without placing the product on the floor.
- Press the button on trigger with thumb, pull the trigger by holding tightly to start the machine.
Adjustment of cutting
Do the adjustment of the cutting when machine is stopped, unplugged.
Press the black button release spool as illustrated fig 5 while pulling both wire on each side of the spool simultaneously.
Repeat several times if necessary to have a length of the radius of the protection guard.
WWW.NIKOLAOUTOOLS.GR
Fig. 2 Fig. 3