Health O Meter Professional 400KL Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS (CONT.)
Caution: It is recommended that the assembly be performed by two people. Use of a
chair is also recommended for the assembly process.
1. Carefully remove the scale platform and
pillar from the carton and place on a flat,
level, and dry surface. Locate the steel rod
at the base of the pillar. Remove the tie wrap
that holds the steel rod / finger pull loop to
the pillar.
2. Obtain a sturdy chair and place the top of
the pillar with the front side facing down on
the seat of the chair, as shown. Place the
platform/base perpendicular to the platform
with the front of the base resting on the floor
and the top of the platform/base facing the
top of the pillar. Remove the four pillar nuts
on the studs and set aside for use in step 3.
Align the four studs on the bottom of the
pillar with the four holes in the top of the
platform/base. Insert the studs into into the
platform/base.
Note: If a chair is not available it is
recommended that one person holds the
platform/base while another person handles
the pillar.
3. Access the underside of the scale base.
Obtain the four pillar nuts removed in step 2
and place onto the studs on the underside of
the scale base. Using the provided wrench,
tighten the pillar nuts to secure the pillar to
the base.
4. Grasp the finger pull loop on the end of the
steel rod and pull towards the lever
extension. Push the lever extension towards
the finger pull loop. Hook the steel rod to the
hole at the end of the lever extension.
Release the finger pull loop and ensure that
the steel rod and lever extension are hooked
together. Carefully position the scale to its
upright position. The scale is now
assembled. Refer to the next page to zero
balance the scale before first use.
UM400KL REV20220928_web
Studs
Pillar nuts
Lever
extension
6
Tie wrap
Steel rod /
finger pull loop
Finger pull
loop
Steel rod