Sauder 423733 Manuel D'instructions page 9

Step 6 Step
Unfold the SMALL BACK (Q) and lay it over the bottom of
å
your unit.
Make equal margins along all four edges of the SMALL
å
BACK (Q). Push on opposite corners of your unit if needed to
make it "square".
Fasten the bottom and side edges of the SMALL BACK (Q) to
å
your unit using the NAILS (10).
NOTE: Do not fasten the upper edge of the SMALL BACK at
å
this time.
Repeat this step for the LARGE BACK (P).
å
NOTE: The LARGE BACK (P) will overlap the SMALL BACK (Q).
å
Do not fasten NAILS along this
edge until the LARGE BACK (P) is
overlapping the SMALL BACK (Q).
423733
Q
www.sauder.com
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(46 used in this step)
P
The LARGE BACK (P) will
overlap the SMALL BACK (Q)
along the SHELF (G).
P
Q
G
10
Page 9