Back Button - Logitech G X56 HOTAS Manuel De L'utilisateur

1. Name of the Part being Modified
This will either be the Stick or the Throttle unit for the X-56. If you wish to change the part
that you're not currently on, use the back button (5) to go back to the selection screen.
2. Modifiable Axes
This shows a list of all modifiable axes. The Stick has three modifiable axes:
- X Axis
- Y Axis
- Rudder Axis
The Throttle unit has six modifiable axes:
- Left Throttle
- Right Throttle
- Rotary 1
- Rotary 2
- Rotary 3
- Rotary 4
3. Manual Axis Adjustment and Test Area
This area will show you how the current response curves / dead zones / saturation points are
set up on the selected axis. You can also adjust the center deadzone, the range saturation,
physical saturation, and the response curve on the selected axis. There is also a cross-hair
which will show the physical position of the axis you are manipulating.
4. Spring Values
This is a reference section when you are adjusting the axes on the Stick. It will act as a guide
for axis modification, and you may choose differing axis curves or deadzones depending on
the Spring you have fitted to the Stick. If you are modifying the Throttle unit's axes you will
not see this reference section.

5. Back Button

Takes you to the device selection screen.
6. Physical Axis Adjustment Slider
Allows the ends of the axes, the far left and far right on the X Axis or full up and full down on
the Y Axis, to be moved inwards towards the center point. It is similar to setting up a deadzone
at the far ends of your axis.
English 18