Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Trim lower fascia – Using a tape measure, marker, and utility knife, measure, mark, and trim the lower fascia. See Figure 2. Check for sensors and or wiring on the
inside of the fascia prior to trimming. Dimensions are approximate.
5. Install Hitch - Raise hitch into position, over the exhaust, and feed the pull wires through bracket slots. Remove pull wires and loosely install conical washers ③,
hex nuts ④ to the hitch. Loosely install carriage bolt ⑤, spacer ⑥, conical washer ⑦, hex nut ⑧ through hook bracket of hitch and vehicle tow hook, see Figure
3 & 4.
©2022 Horizon Global Americas Inc. - Printed in Mexico
C C
C
L
L L
of Vehicle
of Vehicle
of Vehicle
��
��
"
"
Figure 2
��
��
"
��
5
Hook Bracket
of hitch
Sheet 5 of 18
76342NP
6
7
8
Vehicle Tow
Hook
06-24-22
Rev. C
Publicité
Table des Matières
