Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Lower exhaust– Using an exhaust hanger removal tool, lower muffler by removing (4) rearmost rubber hanger for two exhaust mufflers and (1) forward rubber
hanger. A spray of lubricant or soapy water on rubber hangers makes them slide off metal pins more easily. NOTE: Be sure that exhaust is properly supported before
removing rubber hangers.
2. Using a flat head screwdriver, remove (5) rivets from bottom of fascia and
keep for reinstallation.
©2022 Horizon Global Americas Inc. - Printed in Mexico
3. Feed the carriage bolts ① and spacers ② through access holes on both side
frame rails using the pull wires ⑨ for horizontal holes, see Figure 1. Leave pull
wires attached.
Sheet 4 of 18
76342NP
06-24-22
Rev. C
Publicité
Table des Matières
