Initial Set-Up And Operation; Start-Up; Dispensing Of Ice And Water - Dxn Series Manual Version; Dispensing Of Ice And Water - Dxn Series Touch-Free Version - Scotsman Ice DXN Série Manuel D'utilisation Et D'entretien

Initial set‐up and operation
The DXN dispensers are available in two non‐
interchangeable versions:
‐ Manual (Buttons enabled)
‐ Touch‐Free (Buttons not enabled)
In both versions of the DXN Dispenser you can choose
both the mode and the dispensing time among the
following options:
Dispensing mode:
‐ Ice only
‐ Ice and water
Time:
‐ 1 to 15 seconds
‐ Continuous dispensing
Once the Orange Bin Empty light will be switched off
after the start‐up there will be enough ice in the bin to
test the operation of the dispensing system.
Dispensing of ice and water ‐ DXN Series
Manual version
In the manual version the two capacitive buttons are
on and enabled.
Place a glass or a carafe under the desired product
dispensing spout, then press the relevant button
(Water or Ice). The dispensing of ice will stop after the
time set by the installer during the first start‐up, while
water will be dispensed continuously until the button
will be released.
Dispensing of ice and water ‐ DXN Series
Touch‐Free version
In the Touch‐Free version the two backlit buttons are
off.
NOTE: The dispensing time can only be set for ice,
while water will always be dispensed continuously
and at ambient temperature.
The option selected by the user must be configured by
the authorised installer during the first start‐up of the
equipment.
Should you wish to change one of the initial
parameters, or both, you will have to contact the
installer again to have him implement the appropriate
changes.
Start‐up
Open the water tap and switch the equipment on by
pressing the green ON/OFF button.
The DXN Dispenser will switch to start‐up mode and
start the freezing cycle for ice production.
Place a glass or a carafe in front of the desired product
sensor
Once the sensor detects the glass presence, it will start
the dispensing of Water or Ice; the relevant button will
blink on the display.
14