Knight Idex DosaMAX Bucket Fill Manuel D'instructions page 3

INSTALLATION : DOSAMAX OVER THE SINK
1.) Slide tubing through hole on
dispenser arm and snap dispenser
arm onto DosaMAX base
INSTALLATION : DOSAMAX BUCKET FILL
1.)
Drill and screw in three screws in
shown areas to mount bucket arm
base. Snap dispenser arm onto
bucket arm base.
4.) Insert nozzle into discharge
tube.
INSTALLATION : DOSAMAX BOTTLE FILL
1.) Place and hang bottle fill
bracket underneath spout.
S100310 Rev: (6/12)
2.) Snap nozzle and tubing onto
underside of dispenser arm
2.)
Run discharge tube through base
and dispenser arm. Cut discharge
tube to appropriate length.
5.) Snap nozzle and tubing onto
underside of dispenser arm
2.) Drill and screw three screws in
shown areas to hang the bracket
3.) Adjust arm to preferred position
3.) Insert check valve into
discharge tube with blue O-ring
side going in first.
6.) Adjust arm to preferred position
3.) Adjust bottle fill tray to
preferred height
Page 3 of 16