Knight Idex DosaMAX Bucket Fill Manuel D'instructions page 4

INSTALLATION AND OPERATION
1.) Insert pick-up tubing into
chemical container. Place chemi-
cal container into DosaMAX
4.) Use supplied hex wrench and
turn clockwise in hole to lock-in
dosing amount.
7.) Close DosaMAX cover until it
locks into position
DISCLAIMER : Knight LLC does not accept responsibility for the mishandling, misuse, or non-performance of the described items when
used for purposes other than those specified in the instructions. For hazardous materials information consult label, MSDS, or Knight LLC.
Knight products are not for use in potentially explosive environments. Any use of our equipment in such an environment is at the risk of the
user, Knight does not accept any liability in such circumstances.
WARRANTY : All Knight controls and pump systems are warranted against defects in material and workmanship for a period of ONE year.
All electronic control boards have a TWO year warranty. Warranty applies only to the replacement or repair of such parts when returned to
factory with a Knight Return Authorization (KRA) number, freight prepaid, and found to be defective upon factory authorized inspection.
Bearings and pump seals or rubber and synthetic rubber parts such as "O" rings, diaphragms, squeeze tubing, and gaskets are considered
expendable and are not covered under warranty. Warranty does not cover liability resulting from performance of this equipment nor the
labor to replace this equipment. Product abuse or misuse voids warranty.
FOOTNOTE : The information and specifications included in this publication were in effect at the time of approval for printing. Knight LLC
reserves the right, however, to discontinue or change specifications or design at any time without notice and without incurring any
obligation whatsoever.
Page 4 of 16
2.) Turn dial to 50 ml position and
push dial. Repeat pushing action
until DosaMAX is primed.
5.)
If you need to change dosing
amount, use Allen wrench and turn
counter clockwise in hole to unlock dial
8.) Fully push dial in to dose set
dosing amount
50 ml
3.) Turn dial to your preferred
dosing amount. (Warning: Do not
turn over 50 ml)
6.)
If needed, adjust clip to slow
down rate of return on push dial to
prevent immediate repeat dispensing
9.) Dial should not be pushed
again until green indicator is fully
present
S100310 Rev: (6/12)