Whittier Wood Furniture Bistro Chair 74Wb Instructions D'assemblage page 4

3) Insert #8 x 1¼" Pan Head Screws (O) through pocket holes in side aprons (Ha) into Front and Back
Leg Assemblies (W & V).
Lay the Seat (J) face down on a clean protected surface, with the back of the seat hanging over the edge.
Center the leg assembly on the seat and making sure that the seat remains in contact with the back legs,
fasten in place with 2¾" Black Screws (R) through the holes in the front and side aprons into the seat.
See FIGURE 3.
FIG. 4
4) For added strength screw a 1¼" Black Screw (S) through the bottom of both side stretchers into the front
and back legs. See FIGURE 4.
PAGE 4 — 74Wb & 77Wb & 82Wb (Rev. 02/08)
W
R
R
To insert screw at proper angle, the
S
screw head should be approximately
1/2"
1/2" from the nearest surface when
starting screw.
R
Ha
O
O
R
R
J
Ha
S
S
S
S
V
R
FIG. 3