SEA CCT 440 Manuel D'installation Et Programmation page 38

the installed "firmware".
step
POWER UNIT
PROGRAMMING
1
The letter "P" = programme appears on the CHANNEL screen,
while a number appears on the TEMPERATURE screen. The
number represents the programme to select. Select a
programme with «KEY DOWN» and «KEY UP».
PROGRAMME
SETTING
1: Measurement of three probes (CH1 + CH2 + CH3) without
ventilation control (SEA default programme)
2: Measurement of three probes (CH1 + CH2 + CH3) with
2
ventilation control
3: Measurement of four probes (CH1 + CH2 + CH3 + CH4)
without ventilation control
4: Measurement of four probes (CH1 + CH2 + CH3 + CH4) with
ventilation control
5: Advanced menu for the independent control of alarms and
ventilation thresholds for each one of the four channels.
Confirm the selection by pressing the key «ENTER-TEST».
PARAMETERS
3
SETTING
S.E.A. Società Elettromeccanica Arzignanese S.p.A.
PROGRAMMING
DESCRIPTION
Maintain pressed
the 2 inlet keys,
«KEY DOWN» and
«KEY UP», for 2
seconds.
Select the
parameters with
«KEY DOWN» and
«KEY UP» and
confirm the desired
value with the key
«ENTER-TEST».
Select the
parameters with
38
ENGLISH
KEYS
+
+
+ +
+ +
Page 14 of 25