SEA CCT 440 Manuel D'installation Et Programmation page 29

4 Mounting
Crete a square hole 92x92 mm in the installation panel. Place the power unit
and fix it with the provided supports as per the following figure. Insert the
threaded supports in both sides of the power unit (A) in the proper slots and
fix the threaded pin to the front panel (B).
5 Electrical wiring
All the relays come with changeover contact. They can be used for opening
or closing according to the system logic.
See the connection schematic for CCT 440, CCT441 and CCT 442 at the end
of this manual.
S.E.A. Società Elettromeccanica Arzignanese S.p.A.
29
ENGLISH
Page 5 of 25