Panta Safe Light 57092 Mode D'emploi page 8

anchors. Make sure the base is firmly attached.
4. Return the Panta Safe Light to the mounting base. Adjust direction of light by using
360˚ Swivel Twist lock - turn left to loosen, turn right to tighten.
REPLACING BATTERIES AFTER INSTALLATION
Changing batteries after the Panta Safe Light has been installed is easy - you do not need
to remove entire mounting base. When light is dull or no longer active, simply remove
the Panta Safe Light from the mounting base by turning the screw cap on the mounting
base. Twist lock and follow instructions as directed in „INSTALLING BATTERIES".
INFORMATION ABOUT THE PANTA SAFE LIGHT
• The Panta Safe Light will only activate in darkness.
• Motion within 10 metres will cause the Panta Safe Light to turn on.
• The Panta Safe Light will remain on for 20 seconds after motion is detected, then
automatically turn off.
Specifications: IP65, Batteries: 4 x 1.5V D, Power 6V ⎓ 5W
Do not dispose this product at the end of its service life through normal domestic
waste. It has to be disposed through a collection agency that recycles electric and
electronic devices. This is pointed out by the symbol on the product, in the instruction
manual, and on the packaging. Please inquire about local collection agencies that may
be operated by your distributor or your municipal administration. By recycling, making
use of the materials, or other forms of recycling old units you are making an important
contribution to protecting our environment.
Batteries are not part of your household waste and must be taken to an authorized
collection point.
Protection rating III
This product complies with the European directives.
8
Made in China