Panta Safe Light 57092 Mode D'emploi page 7

• This appliance may be used by children above the age of 8 years, by persons of
reduced physical, sensory or mental capabilities or by persons with insufficient
experience or knowledge, provided they are supervised or have received instruction
in the safe use of the appliance and understand the associated risks. Extreme caution
is advised when using the device near children and when leaving it unattended. It
must be ensured that children do not play with the appliance. Use caution when
using close to eyes.
• Take care that the skin, eyes and mucous membranes never come into contact with
battery fluid/acid. In case of contact with battery fluid, immediately rinse affected
areas with plenty of clean water and consult a physician.
SETUP
INSTALLING BATTERIES (ill. 2)
CAUTION: Only use 1.5V batteries Never mix old and new batteries. Never mix
alkaline batteries with normal (zinc-carbon) batteries or rechargeable (nickel-
cadmium) batteries. Never tamper with batteries. Insert the batteries in the battery
compartment according to the polarity markings. Do not insert the batteries in the
opposite direction to the markings. Correctly dispose of batteries.
1. Turn the front of the device anti-clockwise until it is in the unlocked position.
2. Pull the front completely out of the base to expose the battery compartment.
3. Press both locking tabs and remove the battery compartment cover.
4. Insert 4 x 1.5V batteries as shown (batteries not included). Close the cover by placing
the locking tabs flush and pressing down until you hear a click.
5. Place the front of the device back in the base, making sure that the front side is flush
with the device. Twist the device clockwise until it is closed.
NOTE: The Panta Safe Light has a twilight sensor which ensures that the light is
only on in the dark. Be sure to test the Panta Safe Light in a dark area, such as
in a cupboard, before mounting it, to be certain that the batteries are correctly
installed.
INSTALLATION (ill. 3)
1. Remove the base by turning the rotating bolt on the mounting base anti-clockwise.
2. Select the mounting location and mark where the holes should be drilled with a
pencil. Then drill the holes in the marked areas and insert the dowels.
3. Use a screwdriver to screw the supplied screws through the holes in the base into the
7