Herth+Buss AirGuard Notice D'emploi page 76

Operating Instruction
7.6 ID to PC software
EN
TransferthedatafromyourAirGuardtoolto
the software as follows:
Download, install and open the software
Switch on the AirGuard
Switch via Vehicle manufacturer
selectionto"SAVE"and"Confirm"
Use the USB cable supplied to connect
theAirGuardtoyourcomputer
The IDtoPC program indicates
"Connected" as soon as a USB connec-
tionhasbeensuccessfullyestablished
The data are then transferred
automatically.
Please note:
1. The tool installs the USB drivers on
first connection to your computer. This
may take a few minutes. If you have the
impression that this is taking too long,
interrupt the connection and connect
the AirGuard to your PC again with the
USB cable.
2. If you connect the AirGuard to your
computer without selecting the data
log beforehand under Manufacturer
selection, the device assumes that you
want to perform an update and informs
you: Boot Loader Ready. For this reason
always select the data log first.
www.herthundbuss.com
All manuals and user guides at all-guides.com
As soon as the tool is connected to your
computer with the printer software opened
up and the software has detected the device,
all the stored data records will be transferred
automatically.
These can then be selected, viewed or prin-
tedout/storedonyourcomputerasrequired.
The software is set such that the last stored
positionisautomaticallydisplayedfirst.
Connect/Disconnect
Selection of data records
Selection of language
Data input option
Each data record can be exported as
required (image, XLS, TXT)
95990001
76