Herth+Buss AirGuard Notice D'emploi page 56

Operating Instruction
4.2 Automatically duplicating
an OE sensor
EN
Thisfunctionwasdevelopedtoallowyouto
avoid the teaching process for new sensor
IDs via OBD II.
After selecting the function "AUTO DUPLI-
CATE", it is possible to implement "WIRE
PROGRAMMING" by locking the sensor
in position in the sensor compartment or
"WIRELESS PROGRAMMING" by holding
the sensor in parallel with the device. This
alsoworkswithnotyetactivatedHerth+Buss
wheelsensorsalreadyfittedinthetyre.
Please note:
The duplication and programming
function only works with the
Herth+Buss wheel sensor.
Perform the steps described in 4.1.
www.herthundbuss.com
All manuals and user guides at all-guides.com
Function selection:
Use the arrow buttons to select AUTO DU-
PLICATEandpresstheenterkeytoselect.
ID search process:
The AirGuard will now search for the sensor
ID of the OE sensor. The sensor reaction time
may vary according to manufacturer and
sensor type. A successful read-out is con-
firmedwithabeep.
95990001
56