AMQ Activ Guide D'assemblage page 10

Phase 5 | Adjusting Base Width
Step 1
Adjust to desired width. Use #4 allen key to loosen
the factory-inserted screws if not already loose.
IMPORTANT NOTE: Work surface overhangs
larger than .964" (25.0mm) are not allowed on
widths < 64.0" (1625.6mm)
Activ-Pro Assembly Guide | 10
1
Centered screw
bracket
Step 2
Once at correct width – and ensuring that centered
screw brackets are aligned – tighten all inset screws.
2
Use 4mm allen key to
tighten pre-mounted
inset screws
amqsolutions.com