en
When to change the motor protection
filter
Replace this filter every time you start a
new packet of dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters.
How to change the motor protection
filter (dia. 27)
Open the dust compartment lid.
Pull the dustbag out by the grip on
the collar.
Open the blue filter frame fully and
remove the old filter. Hold by the
clean, unsoiled section to remove it.
Replace with a new motor protection
filter.
Close the filter frame.
Fit the dustbag into the blue holder
as far as it will go.
Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
When to replace the exhaust filter
Replace this filter if the exhaust filter
timestrip® change indicator is com-
pletely red (dia. 12).
The indicator lights up after approxim-
ately 50 hours of operation, which is
equivalent to about a year of average
use. You can continue vacuuming when
the light comes on. However, the suc-
tion power will be reduced as will the
effectiveness of the filter if it is not re-
placed in good time.
44
How to replace the exhaust filter
(dia. 28 + 29)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter, making it
sure it goes in properly, then push it
down into position.
Press the exhaust filter timestrip®
change indicator (dia. 10).
After approx. 10 - 15 seconds, a thin
red line will appear in the left hand side
of the display (dia. 11).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 30)
Do not use more than one exhaust fil-
ter at a time.
You can use one of the following ex-
haust filters.
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)