Before Requesting Service - Panasonic MC-V5204 Manuel D'instructions

BEFORE REQUESTING SERVICE

W W A A R R N N I I N N G G
D D i i s s c c o o n n n n e e c c t t t t h h e e e e l l e e c c t t r r i i c c a a l l s s u u p p p p l l y y b b e e f f o o r r e e s s e e r r v v i i c c i i n n g g o o r r c c l l e e a a n n i i n n g g t t h h e e u u n n i i t t . . F F a a i i l l u u r r e e t t o o d d o o
s s o o c c o o u u l l d d r r e e s s u u l l t t i i n n e e l l e e c c t t r r i i c c s s h h o o c c k k o o r r p p e e r r s s o o n n a a l l i i n n j j u u r r y y f f r r o o m m c c l l e e a a n n e e r r s s u u d d d d e e n n l l y y s s t t a a r r t t i i n n g g . .
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Cleaner will
not run.
Poor job of dirt
pickup.
Dust escapes
the paper bag.
E E l l e e c c t t r r i i c c S S h h o o c c k k o o r r P P e e r r s s o o n n a a l l I I n n j j u u r r y y H H a a z z a a r r d d . .
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bag.
2. Broken belt.
3. Clogged hose or nozzle.
4. Hose not inserted fully.
5. Worn brushes.
6. Hole in hose.
7. Dust cover improperly installed.
8. Belt not installed on motor shaft.
1. Bag improperly installed.
2. Bag torn.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
1. Change bag.
2. Replace belt.
3. Clean hose or nozzle area.
4. Insert hose.
5. Replace brushes.
6. Replace hose.
7. Properly install dust cover.
8. Install belt on motor shaft.
1. Properly install bag.
2. Replace bag.
- 38 -